Attach Igniter Wire, Insert Control Panel - Broil King P3PK6N P3XN Series Manual

ATTACH IGNITER WIRE, INSERT CONTROL PANEL

KEPS NUT,
SS, 10-24
B073967(2)
If Side Shelf Accessory was purchased Note: If Side Shelf Accessory was
install at this time. Follow Side Shelf purchased install at this time.
Follow Side Shelf instructions.
Connect the ground wire to the ground lug and run both ground
and electrode wires through hole in Control Panel Shield.
B102523-0-0219
GROUND LUG
Attach the ground wire to the ground lug. Slide both
the ground wire and electrode wire through the hole in
the center of the Control Panel Shield. Ease the
Control Panel Shield over the studs on the Control
Panel. Then insert the two studs through the holes on
the front of the grill. Attach with the two keps nuts.
Remove plastic film from label.
3/8"
CONTROL
PANEL
SHIELD
CONTROL
PANEL
Note: If Side Shelf Ac
purchased install at
Follow Side Shelf ins
Page 25