Emerson Dixell XB Series Installing And Operating Instructions page 8

8.8 MEANING OF THE LEDS
A series of light points on the front panels is used to monitor the loads controlled by the instrument. Each
LED function is described in the following
LED MODE
Flashing
Flashing Programming Phase (flashing with LED
Flashing Drip time active
1, 2, 3, 4, H
1, 2, 3, 4, H Flashing Instrument temporarily stop
AUX, AUX2
9. HOW TO SELECT A CYCLE
1. Push the to move among the cycles C1, C2, C3, C4 and the holding cycle. The related symbol on
the display will be lighted and the cycle will be selected.
NOTE: to pass from a cycle to another one simply push the
mode.
HOLD PHASE: To select H symbol pushing the
Cycles are pre-set with the following values:
1. Cy1: for fast chilling and conservation of foods (hard +soft chill).
2. Cy2: for chilling and fast freezing of foods (hard +soft + freezing cycle).
3. Cy3: for direct fast freezing (only fast freezing cycle)
4. Cy4: for fast freezing avoiding ice skin (hard chill + freezing cycle)
5. HLd: hold mode function
6. dEF: for starting a manual defrost
2. Now the cycle is memorised and can be activated.
9.1 HOW TO MODIFY A CYCLE
1. Verify that none cycle is running. If one cycle is running stop it by pushing the
2. Push the
symbol on the display will be lighted and the cycle will be selected
3. Hold push the
selected cycle (cyS) with its value.
4. Use the UP and DOWN keys to browse the parameters.
5. To modify a parameter push the SET key and use the arrow keys.
6. Confirm the new value by pushing the SET key.
7. The new value is recorded even if the programming is exited by time out.
TO exit: wait for 30 sec or push both SET+UP kyes.
1592006207 XB570L GB r1.1 23.03.2015
table.
ACTION
ON Compressor enabled
Programming Phase (flashing with LED
Anti-short cycle delay enabled
ON Fan enabled
Activation delay active
ON Defrost active
ON Freezing cycle 1, 2, 3, 4 or hold mode active
ON Alarm signalling
ON Aux or Aux2 enabled
to move among the cycles C1, C2, C3, C4 and the holding cycle. The related
key for several seconds till the display will show the first parameter of the
)
)
key when the controller is in stand –by
.
XB570L
key for 3 sec.
6/20