Canon RP10 User Manual page 19

NOTE
If the screen is not displayed, run the software using the following steps.
1) Click the Start button, and then click [All Programs].
• Be sure to Log On as the Administrator.
• The procedure in Windows 8.1/10 is different from the ones described
in this manual. Refer to the Windows 8.1/10 "Help and Support
Center" to select [Run].
2) Click [CANON RP10], and [RP10 Configuration].
RP10 Configuration starts.
B
Under [Select connection method], specify either [USB] or
[Ethernet].
[USB]
Automatically begins searching for connected COM port. The port
name is displayed when the connection is recognized.
NOTE
• When making connection with the USB cable, check the COM port
number in the [Device Manager] screen.
• If the message "RP10 not found. Connect RP10 to this computer"
appears under [USB], confirm the cable connections (see p. 16) and the
STATUS LED (see p. 17).
[Ethernet]
Manually enter the IP address of the CR-150N/CR-120N connected
with the RP10.
Click [Test] to check if the connection is established successfully.
C
Specify whether to use the OPOS driver or Printer driver.
To use with OPOS driver
Select the [Use OPOS Driver] check box, and then select the [Paper
Type].
IMPORTANT
Check with your software provider to determine whether your software is
compatible with the OPOS driver.
NOTE
When this option is selected, the [Run Utility] button is grayed out and you
cannot use the printer driver.
To use with printer driver
Clear the [Use OPOS Driver] check box, then the [Run Utility] button
is enabled to set up the printer driver configuration.
For details of printer driver settings, see "Printer Driver Settings" on
p. 20.
D
Once configuration is complete, click [Apply] to reflect the
changes.
19