Installation - Tripp Lite B123-001-60 Owner's Manual

Installation

Notes:
1. Test to make sure the entire installation works properly before pulling cables through
ceilings/walls.
2. The B123-001-60 has been designed for use with Tripp Lite P568-Series HDMI cables.
To ensure maximum distance and performance, it is recommended that you use Tripp Lite
P568-Series HDMI cabling. For distances over 75 ft. (23 m), 24 AWG cable such as Tripp Lite's
P568-100-HD is required.
3. Although most installations will not require power, a Micro USB port is provided in the event
power is needed. If an image does not appear after performing the following steps, connect a
Micro USB cable from the port on the unit to a USB computer, monitor or USB wall charger
port, such as Tripp Lite's U280-002-W12.
Connect the longer HDMI cable between the source and the SOURCE port on the
1
B123-001-60.
Note: When transmitting a 1080p @ 60 Hz signal, the HDMI cable connecting the source to
the B123-001-60 must be no longer than 125 ft. (38 m).
2
Connect the built-in HDMI cable between the HDMI monitor and the DISPLAY port on
the B123-001-60.
17-06-217-933728.indb 3
3
6/30/2017 2:51:12 PM