Nexgrill 4QW3520000010 Manual page 21

LIGHTING INSTRUCTIONS
Before Lighting
Inspect the gas supply hose prior to turning on the gas. If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use.
Screw the regulator (type QCC1) onto the cylinder, and leak check the hose and regulator connections
before operating the grill (see the "Leak Testing" instructions on page 18).
Only the pressure regulator and hose assembly supplied with the unit should be used. Never substitute
regulators. If a replacement is necessary, contact customer service for proper replacement.
WARNING
Do not use the grill if the odor of gas is present. Contact customer service at 1-800-913-8999 in USA and
1-800-648-5864 in Canada.
TO LIGHT THE MAIN BURNERS
1. Open lid during lighting.
2. Make sure all the knobs are in the "OFF" position, and then turn the Liquid Propane Cylinder valve
"ON" by slowly turning counterclockwise.
3. Push and turn Main Burner control knob to IGNITE/HI, at the same time, press and hold electronic
ignition button to light the burner.
4. Once the burner is lit, release the electronic ignition button and knob.
5. If ignition does not occur in 5 seconds, turn the knob to OFF, wait 5 minutes and repeat the lighting
procedure or light by match.
TO LIGHT THE SIDE BURNER
1. Push and turn Side Burner control knob to IGNITE/HI, at the same time, press and hold electronic
ignition button to light the burner.
2. Once the burner is lit, release the electronic ignition button and knob.
3. If ignition does not occur in 5 seconds, turn the knob to OFF, wait 5 minutes and repeat the lighting
procedure or light by match.
Fig. 26
OFF OFF
IGNITE IGNITE
/ HIGH
/ HIGH
LOW LOW
Main Burners
IGNITE
/ HIGH
3
ELECTRONIC
IGNITION BUTTON
4
21
Side Burners
OFF OFF OFF
IGNITE IGNITE IGNITE
/ HIGH / HIGH
/ HIGH
LOW LOW
OFF
2
1
LOW
LOW