Create Virtual Devices For Hdd With Perccli - Dell EMC ScaleIO Ready Node 14G Manual

Create virtual devices for HDD with PERCCLI

Output similar to the following is displayed:
If the output confirms that VDs exist on the node, perform the next step to
remove them. Otherwise, skip the step.
4. Remove all existing VDs from the node:
perccli64 /c0/vall del
The VDs are removed.
5. Set the controller card boot parameter:
perccli64 /c0 set bootwithpinnedcache=on
The boot parameter of the controller card is defined.
Results
You have verified that the disks are in the UGood (unconfigured, but good) state and
that the controller card boot parameter is set to on. You can now create virtual
devices.
Use PERCCLI to create virtual devices (VDs) for HDDs on a ScaleIO Ready Node
server. The devices can be used as part of a Storage Pool or to provide caching.
Before you begin
Ensure that the PERCCLI disk utility is installed.
You need to create one VD for each HDD. The VDs for HDDs are configured with
Direct IO, write-back, and read-ahead enabled.
Procedure
1. Log in to the server.
2. Create a VD that can be accelerated using a utility such as RFcache, or that will
not be accelerated at all:
perccli64 /c0 add vd type=raid0 drives=<EID>:<Slt> direct wb
ra pdcache=off
Example:
perccli64 /c0 add vd type=raid0 drives=32:6 direct wb ra
pdcache=off
<EID> and <Slt> are the Enclosure ID and Slot ID values, identified in a
where
previous step.
Preparing Disks to add to a ScaleIO SDS
Create virtual devices for HDD with PERCCLI
53