Dell EMC ScaleIO Ready Node 14G Manual page 47

3. Right click the X710 network controller port used by ScaleIO and select
Properties.
4. Click Configure.
5. On the Advanced tab, change the value for each of the following parameters to
Disabled:
Note
For properties with both IPv4 and IPv6 options, configure the property
appropriate for your network.
IPv4 Checksum Offload
l
Large Send Offload V2 (IPv4) / Large Send Offload V2 (IPv6)
l
Encapsulated Task Offload
l
Recv Segment Coalescing (IPv4) / Recv Segment Coalescing (IPv6)
l
TCP Checksum Offload (IPv4) / TCP Checksum Offload (IPv4)
l
6. Click OK.
7. Repeat the above steps for every port on the X710 network controller.
Port Configuration
Change the driver parameters
47