Scaleio Gateway Server Requirements; Prerequisites; Connectivity - Dell EMC ScaleIO Ready Node 14G Manual

Introduction
Operating system
Hypervisors

ScaleIO Gateway server requirements

Component
Supported operating systems

Connectivity

Supported web browsers
Java requirements
Other

Prerequisites

Connectivity
Hardware Configuration and Operating System Installation Guide - Windows Servers
14
Table 2 Supported operating systems - ScaleIO components (continued)
Requirement
Hyper-V
l
Requirement
Windows 2008 R2, 2012 R2, or 2016, including the Visual C++ redistributable 2010
l
package, 64-bit. Server Core editions are not supported.
Every server requires 2 cores and a minimum of 3 GB available RAM.
The following TCP ports are not used by any other application, and are open in the local
firewall of the server: 80 and 443 (or 8080 and 8443).
You can change the default ports. For more information, see "Changing default ports" in the
user documentation.
Internet Explorer 10, or later
l
Firefox, version 42, or later
l
Chrome, version 45, or later
l
1.8 or later, 64-bit
l
For a Windows Gateway, the Windows Management Instrumentation service must be
l
enabled on the IM server and on all Windows ScaleIO nodes.
Do not install the Gateway on a server on which RFcache will be enabled or on which SDC
l
will be installed.
The Gateway server must have connectivity to all the nodes that are being installed. If you
l
are using separate networks for management and data, the server must be able to
communicate with both networks.
The following prerequisites are relevant to using ScaleIO software in the ScaleIO
Ready Node environment.
Ensure that you have the following information at hand:
The IP address range, subnet, and Gateway IP addresses for the management and
l
data network for all servers.
The IP address range, subnet, and Gateway IP addresses for the BMC (iDRAC)
l
port for all servers.
All root and administrator passwords that you plan to set or use on the server and
l
BMC (iDRAC).
To connect via a service PC or laptop computer using SSH/RDP: