Table of Contents
Advertisement
All manuals and user guides at all-guides.com
16.If the information in step 2 on page 15 is a "3,"
write the numbers you circled in Table 2 into the
blank in step 21.
17.If the information in step 2 on page 15 is a "4,"
write the numbers you circled in Table 2 into the
blank in step 21, except replace the "3" with a "4."
18.Press and hold
on (it takes about five seconds).
19.Release
20.Press the
RECALL
21.Press
22.Press the MUTE button while watching
light.
SAT
23.If the
SAT
If
light does not flash at all, go back to step 18.
SAT
24.Press
. You should see both your TV and your
VCR change to the channel you wrote in step 21
above so that you can watch satellite programming.
25.Press the
MENU
receiver
Menu
step 15 on page 18.
26.You are finished programming the remote control.
U
SING
If you installed a VCR using the instructions in Setting Up
to Pass Satellite Programming Through Your VCR to
Your TV on page 14, but you would like to use
switch your TV to the preferred off-air channel, make sure
your VCR is turned off before pressing
20
until both
.
light will flash.
SAT
button.
light flashes three times, go to step 24.
button. If you see the satellite
screen, go to step 26. If not, go to
W
VCR
HEN A
SAT
lights turn
TV
.
I
IS
NSTALLED
to
.
118866
Advertisement
Table of Contents
