Storage; Display Error Codes - eeese Adam User Manual

UK
3
4
7.

Storage

If the dehumidifier will not be used for a long period of time, take the following steps:
1. Remove the plug from the socket and empty the tank, make sure the tank and the
dehumidifier is completely dry. This may take a couple of days.
2. Clean the air filter.
3. Check the dehumidifier for perfect condition to ensure a safe use of it after a long
period of storage.
4. Pack the device with the suitable packaging.
5. Store the dehumidifier in a dust-free location, and out of direct sunlight. Preferably
covered with a sheet of plastic.
8.

Display Error Codes

Please contact your local distributor if any of the error codes below appears.
Code
E1
E2
L3
L4
80
Remove the grate, clean the filter with a vacuum cleaner or
soapy water no hotter than 40°C.
Rinse and dry the grate completely before installing back to
the device.
Error
Temperature sensor
error
Humidity sensor error
Air inlet temperature
is too
high >42ºC
Air inlet temperature is
too low >0ºC
MV-2509-8-2020 . eeese-aircare.com © All rights reserved eeese air care aps
Display
Flash every 30
seconds
Flash every 30
seconds
Slowly flash L3
Slowly flash L4
What is happening
Device still dehumidifies but is
in defrost mode only.
Device still dehumidifies but
is in continuous dehumidifying
mode only.
Compressor stop working, fan
works at low fan speed. 10mins
later, if the temperature decrea-
se to below 40 machine will
work normally.
Compressor stop working,
fan works at low fan speed.
10mins later, if the
temperature increase to
above 2 machine will
work normally.