Table of Contents
Advertisement
Removing the System Memory (RAM)
The computer has two memory sockets for 204 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
DDRIII (DDR3) Up to 1066/1333 MHz. The main memory can be expanded up to 8GB. The SO-DIMM modules sup-
ported are 1024MB and 2048MB DDRIII Modules. The total memory size is automatically detected by the POST rou-
tine once you turn on your computer.
Memory Upgrade Process
1. Turn off the computer, turn it over and remove the battery
-
2. Remove screws
from the component bay cover
1
4
3. Carefully (a fan and cable are attached to the under side of the cover) lift up the bay cover.
4. Carefully disconnect the fan cable
an angle of around 30° angle).
5. The RAM modules will be visible at point
a.
2
3
(page 2 -
(Figure
5a).
, and remove the cover
(note that you need to raise the bottom cover up to
6
5
on the mainboard
(Figure
7
b.
1
4
5).
5b).
7
6
5
6
10
ﾟ
Removing the System Memory (RAM) 2 - 9
Disassembly
Figure 5
RAM Module
Removal
a. Remove the screws.
b. The RAM modules will
be visible at point
7
on the mainboard.
6. Component Bay Cov-
er
• 4 Screws
Advertisement
Table of Contents
