Operation Details - TCL TCE-25CHSD Service Manual

Operation Details

Remote controller
1
2
3
4
5
6.7
8
Remote Control
The remote controller is not presetting as Cooling Only Air Conditioner or Heat Pump by manufacturer.
Each time after the remote controller replace batteries or is energized, the arrowhead will flashes on the front of
Heat or Cool on LCD of the remote controller.
User can preset the remote controller type depending on the air conditioner type you have purchased as follows:
Press any button when the arrowhead flashes on the front of
Press any button when the arrowhead flashes on the front of
If you don t press any button within 10 seconds, the remote controller is preset as Heat Pump automatically.
LOCK/UNLOCK
When you press the buttons "MODE" and "TIMER" at the same time, the remote controller will be locked, all buttons
of the remote controller will be deactive and it displays "Lo" .You can operate again as the same way to unlock the
remote controller.
Air Conditioner Service Manual
ON/OFF button
1
To switch the conditioner on and off.
2
ECO button
In cooling mode,press this button ,the temperature
will increase 2
In heating mode, press this button, the temperature
will decrease 2
MODE button
3
To select the mode of operation
FAN SPEED button
4
To select the fan speed of auto/low/mid/high.
SWING button
5
To activate or deactivate of the movement left or right
of the
6 MUTE button
17
To activate the function of Mute.
HEALTH button
16
7
To switch - on /off
which controls the ionizer or plasma generator only
for inverter type.
15
TURBO button
8
14
In cooling mode, press this button, the unit will give
the maximum cooling temperature with 16
13
In heating mode, press this button, the unit will give
the maximum heating temperature with 31
12
I SET
9
10.11
Press this button, remote will remember location set, then
the next use , press the button will enter the remember set.
Press long time exit I SET.
9
10
9
To switch - activr/deactive I FEEL function. The
conditioner will regulate the room temperature base on the
temperature(0 ~50 ) around the remote controller.This
function will terminate 2 hours later once it's active.
CLEAN button
11
To activate the function
12
To activate or deactivate of the movement up or down
9
of the
9
SLEEP button
13
To activate the function
14
15
TEMP UP button
16
17
Cool
Heat , Heat Pump is set.
on the base of setting temperature:
on the base of setting temperature.
DEFLECTORS
HEALTHY funtion. It is a button
I FEEL button
SWING button
DEFLECTORS
DISPLAY button
To switch on/off the LED display (if present)
TIMER button
To set automatic switching-on/off.
Increase the temperature or time by 1 unit.
TEMP DOWN button
Decrease the temperature or time by 1 unit.
, Cooling Only is set.
.
.
.
air
.
CLEAN
.
.
SLEEP
4