Epson L3210 Series User Manual page 95

Solving Problems
Light Situation
When the power is on or flashing
❏ The printer was not turned off correctly.*
❏ Because the printer was turned off while
operating, the nozzles may have dried
and clogged.
* The power was turned off with a power
strip or breaker, the plug was pulled out of
the outlet, or an electrical failure occurred.
When the power is off
The printer has started in recovery mode
because the firmware update failed.
When the
simultaneously
An ink pad is nearing or at the end of its
service life.
When the
alternately
A borderless printing ink pad is nearing or at
the end of its service life.
A printer error has occurred.
*1 In some print cycles a very small amount of surplus ink may be collected in the ink pad. To prevent ink leakage
from the pad, the printer is designed to stop printing when the pad has reached its limit. Whether and how often
this is required will vary according to the number of pages you print, the type of material that you print and the
number of cleaning cycles that the printer performs. The need for replacement of the pad does not mean that your
printer has ceased to operate in accordance with its specifications. The printer will advise you when the pad
>
Checking Lights and Printer Status
H
b
light and the light flash
H
light and the b light flash
Solutions
❏ After clearing the error by pressing the
button, we recommend performing a nozzle
check. Cancel any pending print jobs.
❏ To turn off the printer, make sure you press the
button.
Follow the steps below to try to update the firmware
again.
1. Connect the computer and the printer with a USB
cable.
2. Visit your local Epson website for further
instructions.
The ink pads need to be replaced.
Contact Epson or an authorised Epson service
provider to replace the ink pad
serviceable part.
When a message saying that you can continue
printing is displayed on the computer, press the
or button to continue printing. The lights stop
flashing for the time being, however, they will
continue to flash at regular intervals until the ink pad
is replaced.
The borderless printing ink pad need to be replaced.
Contact Epson or an authorised Epson service
provider to replace the ink pad
serviceable part.
When a message saying that you can continue
printing is displayed on the computer, press the
or button to continue printing. The lights stop
flashing for the time being, however, they will
continue to flash at regular intervals until the ink pad
is replaced.
Borderless printing is not available, but printing with
a border is available.
Remove any paper inside the printer. Turn the power
off and on again.
If the error continues to occur after turning the power
off and on again, contact Epson support.
95
or
P
*1
. It is not a user-
*2
. It is not a user-