Manual Operation Mode - Glamox NL95 User Manual

5.2 Manual operation mode

Manual operation mode enables user to manualy switch on/off lights in case of emergency. Lights can be switch
on/off by slide switches on the Input modules. In case of manual operation power supply will be directly forwarded to
lights, bypassing all electronics. Fuses will remain in circuit. In case of manual operation, it is recommend that Input
module is disconnected from communication line (RJ45 cable - connectors). Please check troubleshooting section.
POWER ON
F1
FAILURE
5
1 Switches for manual operation are located on Input modules
2 Power supply is directly forwarded to Input modules
3 Fuses will remain in circuit (Lights remain individually fused)
4 Lights are not controlled and their operation needs to be visually checked
5 Navigation lights controller can not control manual operated light
IMPORTANT!!!
There is 230 V ac on PCB. For manual operation use insulated screwdriver.
1
Slide switches for manual light
operation
Slide switches in one direction for
manual operation of light.
ITNL-10-D module
MAIN light switched ON
SPARE light switched ON
CON1 CON2 CON3
CON1 CON2 CON3
MAIN UNIT INPUT
ITNSL-01TP MODULES
2
POWER SUPPLY
35
C.O. VOLTAGE-FREE OUTPUT CONTACT
SYS AL1 AL2 AL3
RX TX
B A B A -
1 2 3 4 5 6 7 8 9 10 12 13 14 15 16 17 18 19 20 21
NMEA 0183
COMMON ALARM OUTPUT RECIEVER
SYSTEM OPERATING
AUDIO ALARM ACCEPT INPUT NMEA 0183
TRANSMITTER
3
MANUAL
OPERATION
1 1
ITNL-10-S module
Light switched ON
Light switched OFF
NL95
CONTROL
4
1 1
Rev.: 4, Print date: 2021-05-05
1