Speed/Temperature Sensor (Option) Installation; Wiring; Power/Nmea0183 Port - Suzuki SMD7 Installation Manual

1. INSTALLATION
1.4

Speed/Temperature Sensor (option) Installation

1.4.1 Speed/temperature sensors ST-02MSB, ST-02PSB
The speed/temperature sensors (ST-02MSB, ST-02PSB) are designed for thru-hull
mounting. Install them as shown in this section.
Mounting considerations
Select a suitable mounting location, considering the following:
• Select a location where the transducer will not be damaged in trailering, launching,
hauling, and storage.
• Select a mid-boat flat position. The sensor does not have to be installed perfectly
perpendicular.
• Select a location in the forward direction viewing from the drain hole, to allow for
circulation of cooling water.
• Select a location away from water flow from keel, water discharge pipe, etc.
• Vibration at the location shall be minimal.
• Do not install fore of the transducer of a fish finder, to prevent disturbance (and loss
of performance) to the fish finder.
Mounting procedure
1. Dry-dock the boat.
2. Make a hole of approx. 51 mm diame-
ter in the mounting location.
3. Unfasten the locknut and remove the
sensor section.
4. Apply marine sealant to the flange of
the sensor. The height of the coat
should be approx. 6 mm.
5. Pass the sensor casing through the
hole.
6. Face the notch on the sensor toward
boat's bow and tighten the flange.
7. Set the sensor section to the sensor
casing and tighten the locknut.
8. Launch your boat and check for water leakage around the sensor.
1.4.2 Temperature sensors T-04MSB and T-04MTB
For installation instructions for T-04MSB and T-04MTB sensors, see the installation
instructions included with the sensor.
Locknut
Face "notch"
toward bow.
51
123
Flange nut
Coat with
Brim
marine sealant.
ø 77
Unit: mm
14
2.

WIRING

The SMD7/9 has three interface connectors at the rear of the unit, as shown in the fol-
lowing figure.
Connections at rear of unit
PWR/NMEA0183 PWR/NMEA0183 XDR XDR NMEA2000 NMEA2000
Port Port Port Port Port Port
To Power and/or
To Transducer* or
NMEA0183 equipment
Matching Box MB-1100
*: includes transducers with or without
temperature/speed sensors.
2.1

Power/NMEA0183 Port

Connect the black and white wires from the power cable to the ship's battery (12 VDC
or 24 VDC), as indicated in the following figure. Connect the black wire to the negative
terminal, then connect the red wire to the positive terminal. Connect the shield wire to
the ship's ground.
Cable connector
Black wire
Battery
Note: Do not connect/disconnect
the cables connected to the unit
while the power is turned on. The
unit may be damaged.
To
NMEA2000
Network
Shield
Red
wire
Ship's
ground
15