HOW TO SELF-CHECK AND INITIALIZE THE HDD & DVD/VCR
1. Turn on the HDD & DVD/VCR.
2. To put the HDD & DVD/VCR into the HDD mode, press [HDD] on the remote control unit.
3. To put the HDD & DVD/VCR into the self-check mode, after pressing [VARIABLE SKIP] button, press the [3],
[6], and [9] buttons on the remote control in that order within three seconds.
Fig. a appears on the screen and all LEDs light.
Table 1: Description of Fig. a
INDICATION
DVD CONNECT STATUS (*1)
HDD CONNECT STATUS (*2)
HDD POWER ON HOURS (*3)
BE Ver. (*4)
FE Ver. (*5)
Sub Micon Ver. (*6)
4. Upon the self-check completion, Fig. b appears on the screen.
All manuals and user guides at all-guides.com
" ******* " differs depending on the models.
Self-Analysys and Report
*1
DVD CONNECT STATUS :
*2
HDD CONNECT STATUS :
*3
HDD POWER ON HOURS :
*4
BE Ver. :
*5
FE Ver. :
*6
Sub Micon Ver. :
Fig. a: Self-Check Mode Screen
Connecting Condition of DVD(F/E)
Connecting Condition of HDD
Value of HDD power on hours obtained from S.M.A.R.T. command. (If not obtainable,
value of HDD power on hours is "0".)
Value in parentheses is the factory setting value. (If no setting, the value is "0".)
B/E version
F/E version
Sub micro controller version
" ******* " differs depending on the models.
Self-Analysys and Report
*7
DVD CONNECT STATUS :
*8
HDD CONNECT STATUS :
HDD POWER ON HOURS :
BE Ver. :
FE Ver. :
Sub Micon Ver. :
*9
FACTORY DEFAULT :
*10
POWER OFF :
Fig. b: Screen of Finishing Self-Check Mode
1-9-1
T3*****B2S-****
R35_028_000
T3***TTP
DESCRIPTION
OK
OK
100(40)
T3*****B2S-****
R35_028_000
T3***TTP
ENTER
POWER
E3B90INT