Table of Contents
Advertisement
Step 11. Rotate down the clips and handle of the SXM GPU board.
Figure 229. Rotate down the clips and handle of the SXM GPU board
After you finish
1. Reinstall the retimer assembly. See "Install the retimer assembly" on page 322.
2. Reinstall the front I/O expansion board module. See "Install the front I/O expansion board module" on
page 277.
3. Reinstall the network adapter. "Install a network adapter" on page 180.
4. Reinstall the 2.5-inch drive cage assembly. See "Install the 2.5-inch drive cage assembly" on page 269.
5. Complete the parts replacement. See "Complete the parts replacement" on page 328.
SXM GPU replacement (trained technician only)
Follow instructions in this section to remove and install the SXM GPU.
Important: This task must be operated by trained technicians.
Remove an SXM GPU
Follow instructions in this section to remove a GPU.
About this task
Important: Removing and installing this component requires trained technicians. Do not attempt to remove
or install it without proper training.
Note: Make sure you have an alcohol cleaning pad available.
Attention:
ThinkSystem SR670 V2 Maintenance Manual
296
Advertisement
Table of Contents
