Epson Stylus Color Stylus Color II Software Setup Manual page 52

4. In the Command Line field (Windows 3.1) or Open field
(Windows 95), type the disk and directory for the utility
(such as A:CALIBRAT or C:\ directory \CALIBRAT if on your
hard disk). Then press Enter or choose OK.
5. When you see the Calibration Utility screen, verify that
Stylus COLOR II is selected as the printer for calibration. If
it isn't, use or
Also make sure Print calibration pattern is selected at the
bottom of the screen. (Use the Tab key to move down, if
necessary.)
6. Press Enter to select Calibrate. The printer starts calibrating.
7. The next screen prompts you to align the black and color
heads. Press Enter to choose Yes. (To align only the black
print head, press Tab to select No.)
Wait for 1 minute while the printer prints a page of multiple
patterns of vertical lines, each of which is assigned an offset
value. Look for the pattern that is most closely aligned.
|
|
Aligned
8. Enter the offset value of the pattern that is most closely
aligned. The printer prints another sheet in black only to
verify that the alignment is correct.
9. If the vertical lines are aligned, select Done. If the lines are
not aligned, select Re-Calibrate; then press Enter to repeat
the calibration.
If you notice later that the vertical alignment of your printed
pages is off, repeat the calibration procedure.
3-4
Using the Printer Driver Utilities
to select it.
|
|
Not aligned