Table of Contents
Advertisement
DISASSEMBLY
5
•
Move the rod back and forth to
purge the cartridge
7
• Tighten the compression block in the
hydraulic cartridge
• Do not exceed a torque of 12Nm
24mm flat spanner
26mm socket
6
• Insert the compression block in the
closed cartridge
• Make sure it is clean before pu�ng it
in place
8
• Move the rod back and forth again to
ensure that the closed cartridge is
properly purged
14
ASSEMBLY
HYDRAULIC CARTRIDGE REASSEMBLY
1
• Apply mul�-grease on the scraper
seals
• Gently insert the stanchions in the
cas�ng
Be
careful
when
passing
the
stanchions through the bushings
Be sure to clean your parts before
reassembly
3
• Tighten the lower cartridge nut to a
torque of 10Nm
16mm Socket
2
• Gently insert the cartridge in the fork
tube
• Apply mul�-grease to the lower rod
o-ring
4
• Apply white grease to the balls and
posi�on them in the holes
• Then insert the seal so that it keeps
the balls in place
15
Advertisement
Table of Contents
