Before Installation - Mitsubishi Electric Lossnay VL-50ES2-E Installation Manual

4. Before installation

1. Remove the mounting plate.
Remove the tape on the back of the unit and
then remove the mounting plate.
- In order to protect the drain pan end, lay the
underlay as shown in the figure below. (Use a
package pad.)
- To prevent scratching of the unit, lay down a
material such as cardboard.
2. Remove the panel.
As shown in the figure below, hold both ends of
the panel and pull toward you.
- After removing the panel, make sure screws
or other items do not get inside the unit.
Panel
Underlay
■ Mounting position diagram (seen from inside)
Mounting plate temporary fixing hole
position (For horizontal mounting)
Edge of main unit
Mounting plate
Unit hanging screw
position
(For vertical mounting)
Mounting plate
temporary fixing hole
position
(For vertical mounting)
Drain pan end
Unit hanging screw position
210.5
310
(min.)
Center line
3. Remove the terminal block cover (VL-
50ES -E only)
2
(For horizontal mounting)
Mounting hole 53 – ø6
216
200
300
184
522
360
Eng-4
Terminal block cover
Power and connection
cable pullout area
(VL-50ES -E only)
2
26.5
(min.)
Air supply/exhaust
hole
(ø120 wall hole)
Unit (mm)