Advertisement
ENGLISH
TONE TRACING ON INSTALLED RJ45/RJ11/RJ12 CABLE (FIG. 7):
1. Connect a known working patch cable to the RJ45 port (if you are
2. Connect the other end of the patch cable to the wall port at the
3. Short press the Tone button
4. Use an analog tracing probe (Klein
5. Repeat steps 2-6 for each unkown
TONE TRACING ON INSTALLED COAX CABLE (FIG. 8):
1. Attach female-to-female Barrel Connector to the
2. Connect a known working patch cable to the Barrel
3. Connect the other end of the patch cable to the
4. Short Press (for less than 2 seconds)
5. Use an analog probe to
6. Repeat steps 2-6 for each
1.800.561.8187
8
tracing a Data cable) or RJ12 port (if you are tracing a voice cable)
at the top of the tester.
satellite location of the cable under test.
D
to
initialize tone generation. Press the
Tone button
D
repeatedly to cycle
through available solid tones (800Hz,
1000Hz, 1200Hz, 1400Hz, 1500Hz) and
alternating frequencies (800Hz/1000Hz,
1000Hz/1500Hz). For voice toning,
repeatedly press the Voice/Up
A
button will change the pins or pairs
of pins the tone is carried on. For data
toning, repeatedly press the Data/Down
C
button will change the pins or pairs
of pins on which the tone is carried.
Tools VDV500-123 recommended,
sold seperately) to determine the
wire or wires on which the tone is
being transmitted (see tone probe
instruction manual for details). The
tone will be loudest at the cable to
which the VDV Scout
Pro 3 is
TM
connected. Mark the cable with a label.
cable location.
F-connector port on the top of the tester.
connector at the top of the main tester body.
wall port at the satellite location of the cable
under test.
the Tone button
to initialize tone
D
generation. Press the Tone
button
D
repeatedly to cycle
through the available tones.
Value (in ohms) of tone being
transmitted will display on
bottom row.
determine the wire on which
the tone is being transmitted
(see tone probe instruction
manual for details). The tone
will be loudest at the cable to
which the VDV Scout
Pro 3
TM
is connected. Mark the cable
with a label.
room that has installed cable.
www.
OPERATING INSTRUCTIONS
.com
FIG. 7
FIG. 8
information@itm.com
Advertisement
