Advertisement
ENGLISH
TESTING CONTINUITY ON TERMINATED OR INSTALLED RJ45/RJ11/RJ12 CABLE (FIG. 1, FIG. 2):
1. Connect one end of the cable under test to the RJ45 port (if testing a data cable) or RJ11/RJ12 port (if testing
2. Connect the other end of the cable under test to the corresponding port on the testing remote. If testing a
3. Press the Data button
4. Interpret the results of the test using the WIRING AND DISPLAY EXAMPLES section.
TESTING CONTINUITY ON TERMINATED OR INSTALLED COAX CABLE (FIG. 3, FIG. 4):
1. Attach female-to-female Barrel Connector to the F-connector port on the top of the tester.
2. Connect one end of the cable to be tested to this adapter.
3. If testing a terminated coax cable, attach a second Barrel Connector to the other end of the cable under test.
4. Connect either a numbered CoaxMap™ Location ID Remote or one of the Test + Map™ ID Remotes to the
5. Press the Video button
6. Interpret the results of the test using the WIRING AND DISPLAY EXAMPLES section.
1.800.561.8187
6
a voice cable) located at the top of the main tester body. If testing a wall port, connect a known good patch
cable from the wall plate to the appropriate port at the top of the main tester body.
wall port, connect a known good patch cable from the wall port to the appropriate port on the testing remote.
NOTE: Location-only ID remotes cannot be used.
or the Voice button
C
FIG. 1
-OR-
-OR-
NOTE: This step is not necessary if testing an installed coax cable, or a cable attached to a wall plate.
Barrel Connector.
B
to begin the test.
FIG. 3
-OR-
-OR-
www.
OPERATING INSTRUCTIONS
on the keypad to begin the test.
A
FIG. 2
-OR-
FIG. 4
.com
-OR-
-OR-
-OR-
information@itm.com
Advertisement
