Time - Time Remaining; Stopping Or Changing A Program; If You Want To Load More Dishes; If The Dishwasher Is Turned Off Due To A Power Failure - Hisense HSGA16FW Operating Instructions Manual

TIME - Time remaining

Once you have chosen a program and options, the time the program took when last used is displayed.
Once you have started the dishwasher, the display shows the remaining program time. The remaining
time is updated after the water for the final rinse has been heated.
This may differ somewhat from time to time depending on the temperature of the water supply, the
amount of dishes, the ambient temperature and other factors.
Front display
Dishwashing Time remaining

Stopping or changing a program

If you want to change program after starting the dishwasher, open the door, then press and hold the
main power switch until the display turns off. Add more detergent if the lid of the detergent dispenser
has opened. Then press the main power switch, choose a new program, and close the door.

If you want to load more dishes

Open the door. The dishwasher stops automatically. Add the dishes and close the door. After a while,
the dishwasher continues the program.

If the dishwasher is turned off due to a power failure

If the dishwashing program was not finished, the interrupted program continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or the door is open for more than 2
minutes.

Once the program has finished

Once the program has finished, "End" appears on the display.
At the end of the program, you will hear a short beep. Chapter Settings describes how to change this
function.
The dishwasher switches off automatically after the program ends. Turn off the water tap after each
use.
Drying
For additional drying the door should be opened 35 mm upon completion of the drying cycle. For
more information, see page 35 in the chapter Technical information.

How to get the best drying results

Fully load the dishwasher.
16
Drying