Pressure Switch Caution (Not recommended by Factory!)
preset adjustment voids all factory water usage specifications.
The pressure switch sets the water level in the washer. As the water level rises, it compresses the air in
the pressure switch hose. When the washer reaches the desired water level, the compressed air in the
pressure switch hose opens the contacts in the switch, shutting off the water. When at the empty level,
the pressure switch contacts are closed allowing the machine to either spin or fill with water. The 1/4"
screw in the middle of the switch adjusts the water level. Counter clockwise will lower the water level, and
clockwise will increase the water level. Before making any adjustments of the pressure switch, drain the
tub and blow the hose clear of possible water bubbles which can cause erratic pressure switch operation.
SINGLE LEVEL
Pressure Switch
Mechinical Pressure switch VS Pressure Sensor
The Drawing below represents the Mechinical Pressure switch and wiring connections. After serial number
W1.15244.001 all washers were converted to the electronic pressure sensor 9732-315-001. If desired previ-
ous C-series machines can be upgraded to the electronic pressure sensor with Kit 9732-314-001, Kit includes
pressure sensor, hold downs, transformer, and wires. The Electronic pressure sensor wiring configuration is
represented in the Diagrams and Schematics in this manual.
66
Part # 8533-082-001 11/21
Changing Factory
DUAL LEVEL
Adjustment
Pressure Sensor
Electronic
The Electronic Pressure Sensor comes standard on all models Starting Septembet, 1st 2015. Machines
Water Level Chart
manufactured before this date can be upgraded with Kit 9732-213-001. The Pressure sensor is adjustable.
The Factory settings chart will let you know the starting values for each machine and by following the
Switch position chart you can adjust the water levels in 1/4 inch increments from that starting value.
67
Part # 8533-082-001 11/21