Advertisement
1)
Only in vehicles with an Active Info Display.
Driving data display (multifunction display)
First read and observe the introductoryinformation and safety warnings
Introduction
The driving data display (multifunction display) shows different driving and consumption values and
has three memories.
Switching between displays
• Vehicles without a multifunction steering wheel: press the rocker switch
⇒
lever
Operating using the wiper lever
• Vehicles with a multifunction steering wheel: press the
using the multifunction steering wheel
Switching between recorders
Press the
button on the wiper lever, or press the
multifunction steering wheel.
Since start recorder
The memory will be deleted if the journey is interrupted for more than two hours.
Since refuelling recorder
Display and storage of the collected driving and consumption values. The memory is deleted when
the vehicle is refuelled.
Long-term recorder
The recorder collects the driving data for up to 19 hours and 59 minutes or 99 hours and 59
minutes driving time or 1,999.9 km or 9,999.9 km distance covered. The memory is deleted if one of
1)
these maximum values is exceeded.
Clearing a driving data recorder
• Select the memory that you wish to delete.
• Press and hold the
multifunction steering wheel for approximately two seconds.
Selecting displays
You can select which driving data you want to display in the Infotainment system
menu
.
Average consumption display
The average fuel consumption is displayed after around 300 metres.
Range display
Approximate distance in km that can still be covered with the same driving style.
SCR range or Range
display
Approximate distance (in km) that can be travelled with the remaining quantity of AdBlue under
current driving conditions. This display appears only as from a remaining range of 2,400 km and
2)
cannot be cancelled.
Average speed display
The average speed is displayed after around 100 metres.
Setting the speed warning
• Select the display Warning at --- km/h or Warning at --- mph.
• Press the
button on the wiper lever or the
steering wheel to save the current speed and activate the warning system.
• Within around five seconds, set the speed with the
the
or
buttons on the multifunction steering wheel. Then press the button
or
or wait a few seconds. The speed is now saved and the warning
is activated.
.
or
button
.
button on the
button on the wiper lever or the
⇒
button on the multifunction
rocker switch on the wiper lever or
⇒
on the wiper
⇒
Operating
button on the
Vehicle settings
®
Advertisement
