Connecting To A Macintosh; Install The Printer Software; Installing The Windows Software - Epson Stylus 1520 Quick Setup Manual

Connecting to a Macintosh

1. Turn off the printer and your Macintosh.
2. Connect your serial cable to the serial connector on the
back of the printer.
Note:
If you don't have a serial port on your
Macintosh, use the USB Adapter Kit from
Epson (part number C-USB-PK4).
Connect the parallel connector on the
adapter to the printer's parallel port, and
the USB connector to your Macintosh's
USB port.
3. Connect the other end of the cable to either the
on your Macintosh.
8

Install the Printer Software

Now you need to install the printer software so you can control printing from your
computer. See the section below for your operating system.

Installing the Windows Software

1. Make sure your printer is off. Then turn on your computer.
Note:
If you see a New Hardware Found wizard, click Cancel. Then make sure
your printer is off.
2. If necessary, enter your administrator password.
printer port or the
9
Quick Setup
modem port