Load Paper; Connect The Printer To Your Computer; Connecting To A Pc; Connecting To A Macintosh - Epson Stylus Color 850 Start Here Manual

4 Load paper

1. Open the output tray extensions and slide the
left edge guide all the way to the left.
2. Load a stack of plain paper with the printable
side up and place it against the right edge
guide. Then slide the left edge guide to the
paper's left edge, making sure the stack is not
higher than the arrow mark on the guide.
output tray
extensions
don't load
paper
above this
arrow
5 Connect the printer to
your computer
If you're using an optional interface card in your printer,
see Appendix A of your User's Guide for instructions on
installing it and connecting it to a network.

Connecting to a PC

1. Turn off the printer and computer.
2. Connect the cable to
the printer's parallel
interface, then fasten
the wire clips to lock
it in place.
3. Connect the other
end of the cable to
your computer's
main parallel port
(LPT1) and secure it
as necessary.

Connecting to a Macintosh

1. Turn off the printer and Macintosh.
2. Connect the cable to the printer's serial connector.
3. Connect the other end of the cable to either the
modem or printer port on your Macintosh.
Note:
If you're using a PowerBook ®
modem port, use that port and set it to Normal. If your
Macintosh has an internal modem, use the printer port.
with a combination printer/