Removing The Push Tractor - Epson Stylus 1000 User Manual

If the perforation is not aligned with the tear-off edge, adjust
the tear-off position as follows:
1. Make sure the paper is in the tear-off position.
2. While holding down the ALT button, press the
ECONOMY/CONDENSED (up) or FONT (down) button to
adjust the position. The printer remembers the new
position even after you turn it off.
3. Tear off any printed pages.
Note:
The printer has a minimum and maximum tear-offposition. If
try
you
printer beeps and the paper stops moving.
When the paper reaches the
printer beeps. Use the factory setting as a reference point when
adjusting the tear-oflposition.

Removing the push tractor

Tear off any printed pages. Press the LOAD/EJECT button to
1.
feed the paper backward out of the printer and into the
paper-park position. Remove the paper from the push
tractor.
Caution:
R
2. Turn off the printer. Attach the paper separators as shown on
page l-6.
3. Lower the release lever to the single-sheet position.
to move the tear-ofiposition beyond these limits, the
Never feed labels backzuard. To remove labels from the
printer, see "Labels" later in this chapter.
Make sure you tear offyour printed document before
feeding paper backzuard. Reverse feeding several pages at a
time may cause a paper jam.
factory-set
tear-off position, the
Paper Handling 2-13