Opening The Burner; Closing The Burner - Riello RLS 800/M MX Installation, Use And Maintenance Instructions

7.3

Opening the burner

Disconnect the electrical supply from the burner
by means of the system main switch.
DANGER
Close the fuel shut-off valve.
DANGER
Wait for the components in contact with heat
sources to cool down completely.
D10721
7.4

Closing the burner

Refit following the steps described but in reverse order; refit all
burner components as they were originally assembled.
After carrying out maintenance, cleaning or
checking operations, reassemble the cover and
all the safety and protection devices of the burner.
Maintenance
2
6
5
5 3
4 7
 Remove the tie-rods 1) and 6)(Fig. 45) of the lever for
moving the head and opening the dampers, loosening the
nuts 2).
 Disconnect the socket 3) of the servomotor.
 Disconnect the socket 7) of the derivation unit.
 Disconnect the socket 4) of the gas pressure switch.
 Remove the screws 5).
 At this point, it is possible to open the burner on the hinge.
39 GB
5
1
5
Fig. 45
20148124