CLA-VAL X144D Quick Start Programming

SETTINGS – VALVE (Adjust meter size and valve size parameters)
Note: Stylus Pen Recommended for Touch Screen Programming
From Flow Rate or Sensor Frequency screen, select
6" 100-01 v1.0
VALVE
Select
YES
Select correct METER size from chart below
X144D Sizes
Size 1
Size 2
Full Port Valve Sizes
Size 3
Reduced Port Valve Sizes
Size 4
Save configuration
YES
SETTINGS – OUTPUT (Adjust Gain, mA Scaling, mA Filtering, Pulse Weight, and 4-20mA Output Test)
OUTPUT
Select
YES
Set the Gain? Default Gain is 1.00. Use arrow keys to adjust gain to desired value. Increasing or decreasing
1.00
value offsets factory calibration. Select
NEXT
Use arrow keys to set 20mA Full Scale Output. Match 20mA value to customer display and/or
Set the 20mA Value?
002250.00
SCADA. Select
NEXT
Set Filter Strength Default Filter is 4.00. Use arrow keys to increase or decrease filtering of 4-20mA signal. The
4.0
width
higher the average filter strength, the longer the averaging time. Select
NEXT
then
VALVE YES
1
2 2-1/2
4 4
then
OUTPUT YES
to continue.
NEXT
X144D e-FlowMeter
Quick Start Programming
to access
to configure meter size
2 3
3 4 6 8 10 12
4 6 8 10 12 14
to configure output.
to continue.
NEXT
menu.
Settings
4
14 16 18 20 24 30
16 18 20 24 CF CF
to continue.
NEXT