Wake-Up Mode (Mode 4); Configuration Mode (Mode 5) - Ebyte E70-433T30S User Manual

Chengdu Ebyte Electronic Technology Co,;Ltd
Receiving
Configuring
Note

6.6 Wake-up Mode (Mode 4)

Status M0=0 M1=0 M2=1
Transmitting Transmission is available.
Receiving Receiving is not available.
Baud rate & Under this mode, the baud rate and air data rate are independent, both receiver and transmitter can have different
air data rate baud rate but same air data rate.
It can wake up the receiver under mode 6; wake up code will be added automatically before transmitting, the code
Advantage
number depends on the wake up time.
Disadvantage The transmission time is long, only applicable to wake up the receiver, not applicable for common data transmission.
Applications For waking up the receiver under WOR mode.
Under wake up mode, the single data packet length is 84 bytes (excluding the address and channel for directional
Note
transmission).

6.7 Configuration Mode (Mode 5)

Status M0=1 M1=0 M2=1
Transmitting Transmission is not available. Serial data received are considered as configuration command.
Receiving Receiving is not available.
Parameter configuration can be made in configuration mode with specific instruction format and UART 9600,
Configuration
8N1.
When entering other modes from configuration mode, the module will reconfigure parameters, AUX keeps low
Note level during configuration;
After configuration completed, it outputs high level, so users are recommended to check the AUX rising edge.
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2019，
Receiving is not available.
Parameter configuration can be made in configuration mode with specific instruction format and UART 9600,
8N1.
When entering other modes from configuration mode, the module will reconfigure parameters, AUX keeps
low level during configuration;
After configuration completed, it outputs high level, so users are recommended to check the AUX rising edge.
E70-433T30S user manual
15