Faq; Communication Range Is Too Short; Module Is Easy To Damage - Ebyte E70-433T30S User Manual

Chengdu Ebyte Electronic Technology Co,;Ltd
the performance. It is recommended to keep them away from the module according to the strength of the interference.
If necessary, appropriate isolation and shielding can be done；
 Assume that there are traces with large electromagnetic interference (high-frequency digital, high-frequency analog,
power traces) around the module that will greatly affect the performance of the module. It is recommended to stay
away from the module according to the strength of the interference.If necessary, appropriate isolation and shielding
can be done.
 If the communication line uses a 5V level, a 1k-5.1k resistor must be connected in series (not recommended, there is
still a risk of damage)；
 Try to stay away from some physical layers such as TTL protocol at 2.4GHz , for example: USB3.0；

The mounting structure of antenna has a great influence on the performance of the module. It is necessary to ensure
that the antenna is exposed, preferably vertically upward. When the module is mounted inside the case, use a good
antenna extension cable to extend the antenna to the outside；

The antenna must not be installed inside the metal case, which will cause the transmission distance to be greatly
weakened.

11 FAQ

11.1 Communication range is too short


The communication distance will be affected when obstacle exists.
 Data lose rate will be affected by temperature, humidity and co -channel interference.
 The ground will absorb and reflect wireless radio wave, so the performance will be poor when testing near groun d.
 Sea water has great ability in absorbing wireless radio wave, so performance will be poor when testing near the sea.

The signal will be affected when the antenna is near metal object or put in a metal case.
 Power register was set incorrectly, air data rate is set as too high (the higher the air data rate, the shorter the
distance).
 The power supply low voltage under room temperature is lower than 2.5V , the lower the voltage, the lower the
transmitting power.
 Due to antenna quality or poor matching between antenna and module.

11.2 Module is easy to damage

 Please check the power supply source, ensure it is 2.0V~3.6V, voltage higher than 3.6V will damage the module.

Please check the stability of power source, the voltage cannot fluctuate too much.
 Please make sure antistatic measure are taken when installing and using, high frequency devices have electrostat ic
susceptibility.
 Please ensure the humidity is within limited range, some parts are sensitive to humidity.
 Please avoid using modules under too high or too low temperature.
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2019，
E70-433T30S user manual
24