Configuration Mode (Mode 3); Wake-Up Mode (Mode 4); Configuration Mode (Mode 5) - Ebyte E70-900T S Series User Manual

Chengdu Ebyte Electronic Technology Co,;Ltd

6.5 Configuration Mode (Mode 3)

Status M0=1 M1=1 M2=0
Transmitting Transmission not available, serial data received will be discarded.
Receiving Receiving is not available.
Parameter configuration can be made in configuration mode with specific instruction format and UART 9600,
Configuring
8N1.
When entering other modes from configuration mode, the module will reconfigure parameters, AUX keeps low
level during configuration;
Note
After configuration completed, it outputs high level, so users are recommended to check the AUX rising edge.

6.6 Wake-up Mode (Mode 4)

Status
Transmitting
Receiving
Baud rate & air
data rate
Advantage
Disadvantage
Applications
Note

6.7 Configuration Mode (Mode 5)

Status M0=1 M1=0 M2=1
Transmitting Transmission is not available. Serial data received are considered as configuration command.
Receiving Receiving is not available.
Configuration Parameter configuration can be made in configuration mode with specific instruction format and UART 9600, 8N1.
Chengdu Ebyte Electronic Technology Co,;Ltd
Copyright ©2012–2023，
M0=0 M1=0 M2=1
Transmission is available.
Receiving is not available.
Under this mode, the baud rate and air data rate are independent, both receiver and transmitter can have
different baud rate but same air data rate.
It can wake up the receiver under mode 6; wake up code will be added automatically before transmitting, the
code number depends on the wake up time.
The transmission time is long, only applicable to wake up the receiver, not applicable for common data
transmission.
For waking up the receiver under WOR mode.
Under wake up mode, the single data packet length is 84 bytes (excluding the address and channel for
directional transmission).
E70-900TxxSx_user manual
21