Table of Contents
Advertisement
Available languages
Available languages
ENGLISH
Use only the appropriate type of cut-
u
ting line. Never use metal cutting line
or fishing line.
Be careful not to touch the line trim-
u
ming blade.
Take care to keep the mains cable
u
away from the cutting line. Always be
aware of the position of the cable.
Keep hands and feet away from the
u
cutting line at all times, especially
when switching on the motor.
Before using the appliance and after
u
any impact, check for signs of wear or
damage and repair as necessary.
Never operate the appliance with
u
damaged guards or without guards in
place.
Take care against injury from any de-
u
vice fitted for trimming the filament line
length. After extending new cutter line
always return the machine to its nor-
mal operating position before switching
on.
Always ensure that the ventilation slots
u
are kept clear of debris.
Do not use the lawn trimmer (edge
u
trimmer), if the cords are damaged or
worn.
Keep extension cords away from cut-
u
ting elements.
Additional safety instructions for
batteries and chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not store in locations where the
u
temperature may exceed 40 °C.
Charge only at ambient temperatures
u
between 10 °C and 40 °C.
8
(Original instructions)
Charge only using the charger pro-
u
vided with the tool.
When disposing of batteries, follow
u
the instructions given in the section
"Protecting the environment".
Chargers
Use your BLACK+DECKER charger
u
only to charge the battery in the tool
with which it was supplied. Other bat-
teries could burst, causing personal
injury and damage.
Never attempt to charge non-recharge-
u
able batteries.
Have defective cords replaced immedi-
u
ately.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
$
The charger is intended for
indoor use only.
Read the instruction manual
before use.
Electrical safety
#
Your charger is double insu-
lated; therefore no earth wire is
required. Always check that the
mains voltage corresponds to the
voltage on the rating plate. Never
attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Labels on appliance
The following warning symbols are found on the appliance
along with the date code:
Advertisement
Table of Contents
