Black & Decker STC1815 User Manual
Hide thumbs
Also See for STC1815:
- Original instructions manual (113 pages) ,
- Manual (114 pages) ,
- Original instructions manual (113 pages)
Advertisement
Advertisement
Table of Contents
Related Manuals for Black & Decker STC1815
Summary of Contents for Black & Decker STC1815
- Page 1 STC1815 www.blackanddecker.com.au www.blackanddecker.co.nz STC1820...
-
Page 5: Safety Instructions
(Original instructions) ENGLISH Do not allow children or animals to Intended use Your Black & Decker trimmer has been designed for trimming come near the work area or to touch and finishing lawn edges and to cut grass in confined spaces. This appliance is intended for consumer use only. -
Page 6: Residual Risks
ENGLISH (Original instructions) Residual risks. Inspection and repairs Additional residual risks may arise when Before use, check the appliance for using the tool which may not be included damaged or defective parts. Check for in the enclosed safety warnings. These breakage of parts and any other condi- risks can arise from misuse, prolonged tions that may affect its operation. - Page 7 (Original instructions) ENGLISH Only use the appliance in the upright Take care against injury from any de- position, with the cutting line near the vice fitted for trimming the filament line ground. Never switch the appliance on length. After extending new cutter line in any other position.
-
Page 8: Before Use
9. Power select (STC1820 Only) 10. Edge wheel (STC1820 Only) required. Always check that the 11. Edge guide (STC1815 Only) mains voltage corresponds to the Assembly voltage on the rating plate. Never Warning! Before assembly, make sure that the tool is attempt to replace the charger switched off and the battery has been removed. - Page 9 (Original instructions) ENGLISH Adjusting the position of the secondary handle (fig. lights green continuously. The charger and the battery can be left connected indefinitely with the LED illuminated. The LED will change to flashing green (charging) state as the charger The second handle (5) can be adjusted to provide optimum occasionally tops up the battery charge.
-
Page 10: Troubleshooting
ENGLISH (Original instructions) Switching on and off Align the tabs (21) on the spool cover with the cut outs (25) in the spool housing. To switch the tool on, press in and hold the lock off button Push the cover onto the spool housing until it snaps (3) then squeeze the trigger lever (1). -
Page 11: Technical Data
Technical data Unplug the charger before cleaning it. Your charger does not require any maintenance apart from regular cleaning. STC1815 STC1820 Regularly clean the ventilation slots in your tool/appliance and charger using a soft brush or dry cloth. - Page 12 Australia & New Zealand Stanley Black & Decker www.blackanddecker.com.au www.blackanddecker.co.nz Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ) 90622985 05/2015...