Set Up Reminders And Alerts - Carrier Comfort Series Owner's Manual

Absolute Temperature Set a specific heat and cool set point to
d
be used when an event is initiated by the Utility company. If the
set point at the time of the event is more favorable (lower in heat
mode or higher in cool mode) than what you have programmed,
the Comfort Series Wi- -Fi Thermostat will use the more favorable
set point for the duration of the event.
Relative Temperature Program a temperature set back (heat) or
d
set forward (cool) from your existing set point. For example, if
you program a 4° F set forward, and your current cool set point is
76° F, during an event your Comfort Series Wi- -Fi Thermostat set
point will change to 80° F until the event has expired.
System Off If this option is selected, the Comfort Series Wi- -Fi
d
Thermostat will turn off heating and cooling for the duration of
this event.
Duty Cycle This option allows you to program the maximum
d
amount of time the system will run during a 1 hour period. For
example, if you select 30%, the air conditioner will run for a max-
imum of 18 (0.3 x 60) minutes regardless of whether the set point
has been met. 0% essentially turns the system off, whereas 100%
runs the system at full capacity.

Set Up Reminders and Alerts

Your Comfort Series Wi- -Fi Thermostat can be programmed to remind
you about required filter changes and regular maintenance.
NOTE: If you are unsure what equipment you have installed, or if you
need to replace instead of clean your filters, please contact your heating
and cooling contractor, or consult your original equipment manuals for
the recommended maintenance procedures.
To set up Reminders:
From the Home screen, press MENU.
Select Reminders and Alerts.
Adjust each option to your personal preferences.
23