TOHATSU MFS 25C Owner's Manual page 92

92
EMISSION CONTROL SYSTEM INFORMATION
ENOM00034-A
EPA pressurized portable
fuel tank requirements
EQUIPPED FOR UNITED STATES AND
CANADA MODEL
The Environmental Protection Agency
(EPA) required portable fuel systems that
are produced after January 1, 2011 for use
with outboard engines to remain fully
sealed (pressurized) up to 34.4 kPa (5.0
psi). These tanks may contain the follow-
ing:
An air inlet that opens to allow air to
enter as the fuel is drawn out of the
tank.
An air outlet that opens (vents) to the
atmosphere if pressure exceeds 34.4
kPa (5.0 psi). A hissing noise may be
heard as the tank vents to the atmo-
sphere. This is normal.
When installing the fuel tank cap, turn
the cap to the right until you hear two
clicks. This signals that the fuel cap is
fully seated. A built-in device prevents
overtightening.
The fuel tank has a manual vent screw
which should be closed for transporta-
tion and full open for operation and
cap removal.
Since sealed fuel tanks are not openly
vented, they will expand and contract as
the fuel expands and contracts during
heating and cooling cycles of the outside
air. This is normal.
14
ENOM00036-0
EPA approval Primer bulb/
hose assembly
EQUIPPED FOR UNITED STATES AND
CANADA MODEL
TOHATSU adopts Primer bulb/hose
assembly approved by the Environment
Protection Agency (EPA).
Please use the EPA approved primer
bulb/hose assembly with the identifica-
tion mark on the fuel connector.
ENOW00021-0
CAUTION
Be sure to use EPA approved tank and EPA
approved primer bulb/hose assembly as a
set. Confirm shapes of EPA approved tank
and regular tank.
1
1. Except for U.S. model (regular tank)
2. For U.S. and Canada model (EPA approved tank)
ENOF00111-0
2
ENOF00024-1