TOHATSU MFS 25C Owner's Manual page 70

70
INSPECTION AND MAINTENANCE
Description
Propeller
Gear oil
Lower Unit
Cooling water
inlet
Water pump
*1
Power tilt
*1
Warning system
Bolts and Nuts
Throttle wire
Remote control cable
Sliding and Rotating Parts.
Grease Nipples
Outer Equipment
Anode
*1: Have this handled by your dealer.
ENON00030-0
Note
Your outboard motor should receive careful, and complete inspection at 300 hours. This is the
best time for major maintenance procedures to be carried out.
ENOM00091-A
Engine oil replacement
10
ENOW00091-0
You may be injured due to high engine tem-
peratures if you fill engine oil just after stop-
ping. Changing engine oil should be done
after the engine has been cooled.
ENOW00092-A
Do not overfill engine oil, or engine oil
could leak and/or engine could be dam-
aged. If engine oil level is over upper limit
marks of oil gauge, drain oil to level lower
than upper limit.
Inspection intervals
First 20 Every 50 Every 100
hours or 1 hours or 3 hours or 6
month months
Replace
*1
CAUTION
CAUTION
Every 200
Inspection procedure
hours or 1
months year
Check for bent blades, damage, wear.
Replace if necessary. (See page 76)
Change or replenish-oil and check for
Replace
water leaks. (See page 75)
Check clogging
Check for wear or damage and replace
Replace
if necessary
Check & replenish oil, manually
operate
Check function
Retighten
Apply and pump in grease. (See
page 81)
Check for corrosion.
Check for corrosion and deformation.
Be sure that outboard motor is in upright
and level position when che cking or
changing oil.
Stop engine immediately if low oil pres-
sure warning lamp is lit or oil leak is found,
or engine could be severely damaged.
Consult dealer.
Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
Remarks
360 mL (12.2
fl.oz.)
Replace impeller
every 12 months.
Replace if
necessary.