TOHATSU MFS 25C Owner's Manual page 45

ENOM00044-0
Engine speeds
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 400 min
(rpm) for several minutes.
Clutch in (In gear)
-1
850 min (rpm)
ENOM00972-0
Free throttle lever (Side mount RC
type)
ENOW00956-0
CAUTION
Keep the free throttle lever fully closed-
position when start the engine.
The free throttle lever is inoperative
unless the control lever is in neutral.
Also, the control lever is inoperative
unless the free throttle lever is returned
to the fully-closed position.
The free throttle lever is for warm-up
operation.(Not required for engine start-
ing) With the control lever in neutral,
move the free throttle lever upward to
open the throttle.
1. Fully-open
2. Fully-closed
-1
Clutch off (Out of gear)
-1
850 min (rpm)
1
2
ENOF00934-0
ENOM00 -0
Trolling engine speed control
function (except for normal tiller
handle type)
If the main switch key is pressed for 1
(one) second during idling or trolling
operation, engine revolution change.
ON
Each time the main switch key is pressed
in the above manner, engine speed
changes as follows.
Starting
-1
850min (rpm) 950min
-1
950min (rpm) 1050min
Buzzer short sounded one time, when set
-1
to 850 min (rpm) engine speed, and tells
the lowest engine speed was set.
Buzzer short sounded twice, when set to
-1
1050 min (rpm) engine speed, and tells
the highest engine speed was set.
Reset the engine speed when after
engine restarted and or engine speed is
-1
above 3,000 min (rpm), and then trolling
engine speed to be 850 min
standard.
In addition, this function does not oper-
ate when battery voltage is lower than
specified, set engine idle and trolling
engine speed to 850 min
matically.
ENGINE OPERATION
1
second
ENOF00876-0
-1
(rpm)
-1
(rpm)
-1
(rpm) as
-1
(rpm) auto-
45
7