Engine Operation; Before Starting; Fuel Feeding - TOHATSU MFS 25C Owner's Manual

36

ENGINE OPERATION

ENOM00042-0

Before starting

ENOM00246-0
Oil Level checking
Check the engine oil level before each
use. If the oil level is low or too high, the
life of the engine will be shortened signif-
icantly.(To properly check the engine oil
level follow the instructions,
1
3
7
1. Filler cap
2. Dipstick
3. Filler port
1. Upper limit
2. Lower limit
ENOW00027-B
Before starting engine for the first time after
reassembling engine or off-season storage,
page 66)
see
ENOF01121-A
1
ENOF00113-0
2
CAUTION
disconne c t stop switch lock and crank
approximately 10 times in order to prime the
oil pump.
ENOM00044-A

1. Fuel feeding

ENOW00029-A
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
2
could blast out through the fuel tank cap in
case the cap is loosened by using another
procedure when internal pressure of fuel
tank is raised by heat from sources such as
sun light.
ENOW00030-B
When using EPA approval fuel tank, only use
a primer bulb/hose assembly that has a Fuel
Demand Valve (FDV) installed in the fuel hose
or a sealing mechanism in the fuel connector
as shown below.
FDV and fuel connector that has an sealing
mechanism prevent pressurized fuel spill-
age when the fuel connector is connected to
the engine.
1
1. FDV in fuel hose
2. Sealing mechanism in fuel connector
3. Identification
Do NOT use a primer bulb/hose assembly
that does not contain a Fuel Demand Valve
or a sealing mechanism as shown below:
WARNING
WARNING
2
3
ENOF00035-0