Power Cords - IBM 7316-TF5 Installing

• One #1 Phillips screwdriver (to install or remove the inner slide-rails)
• One #2 Phillips screwdriver (to replace the cable-management arm)

Power cords

This topic provides the information about the power cords and the part number of the power cords for
different countries across the world.
For your safety, IBM provides a power cord with a grounded attachment plug to use with this IBM
product. To avoid electrical shock, always use the power cord and plug with a properly grounded outlet.
IBM power cords used in the United States and Canada are listed by Underwriter's Laboratories (UL) and
certified by the Canadian Standards Association (CSA).
For units intended to be operated at 115 volts: Use a UL-listed and CSA-certified cord set consisting of a
minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in length and a parallel
blade, grounding-type attachment plug rated 15 amperes, 125 volts.
For units intended to be operated at 230 volts (U.S. use): Use a UL-listed and CSA-certified cord set
consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in length
and a tandem blade, grounding-type attachment plug rated 15 amperes, 250 volts.
For units intended to be operated at 230 volts (outside the U.S.): Use a cord set with a grounding-type
attachment plug. The cord set should have the appropriate safety approvals for the country in which the
equipment will be installed.
IBM power cords for a specific country or region are usually available only in that country or region.
Table 13. Power cord part numbers and associated regions
IBM power cord part number
39M5206
39M5102
Installing the 7316-TF4 18.5-Inch Flat Panel Rack-Mounted monitor and keyboard 31
Used in these countries and regions
China
Australia, Fiji, Kiribati, Nauru, New Zealand, Papua
New Guinea