Epson EPL-N7000 Network Manual page 92

Bindery and NDS
❏ You can check the bindery context path from the server
console by using the SET BINDERY CONTEXT command.
❏ If the bindery context path has not been set, or if you want to
use the printing environment of another context from a
non-NDS client, you need to specify the context for the
bindery context. Use the SET BINDERY CONTEXT command
to set the context in the AUTOEXEC.NCF file.
❏ You cannot use the bindery print server mode with EpsonNet
Config if you are running Novell Client for Windows 95/98
version 3.00 or Novell Client for Windows NT version 4.50.
To configure the network interface for bindery mode, use
Novell IntranetWare Client or EpsonNet Config with Web
Browser.
See your NetWare documentation for more information.
Time required to recognize the network interface
It takes up to two minutes for the NetWare server to recognize
the network interface, after the printer is turned on. During this
start-up time, the status sheet does not show the correct
information.
Frame type
The same frame type should be used for the NetWare server and
IPX router on the same network. If more than one frame type is
used on the same network, bind all the frame types to the NetWare
servers and IPX routers.
For NetWare 5.x
The IPX protocol must be installed (bound) on the NetWare 5.x
server.
92
How To