Epson EPL-N7000 Network Manual page 147

5. To assign an IP address manually, enter the IP address, the
subnet mask, and the default gateway. Be sure the IP address
does not conflict with any other devices on the network.
Note:
If there is a server or a router functioning as a gateway, enter the IP
address of the server or the router for the gateway address. If there
is no gateway, leave the default values there.
6. If you want to get a private address between 169.254.1.1 and
169.254.254.254 automatically when an IP address cannot be
obtained by the DHCP server, leave it at Enable for Set Using
Automatic Private IP Addressing (APIPA); otherwise, select
Disable.
7. When setting an IP address using the ping command, select
Enable for Set Using PING. Select Disable when setting an
IP address with EpsonNet Config; this prevents any
unexpected change of the IP address.
Note:
Be sure to select Disable when not using ping; this prevents an
unexpected change of the IP address by EpsonNet WebManager.
8. Select Enable for Acquire DNS Server Address
Automatically if you want to acquire the DNS server address
using the DHCP server.
If you want to enter the DNS server address manually, select
Disable and then enter the IP address of the DNS server.
9. Select Enable for Acquire Host Name and Domain Name
Automatically if you want to acquire the host name and the
domain name using the DHCP server.
If you want to specify manually, enter the host name and the
domain name in the text boxes.
Network Software
3
3
3
3
3
3
3
3
3
3
3
3
147