Table of Contents
Advertisement
The information in this section is written for dealer ser-
vice personnel. The repair described here requires
special skills and tools. If your shop is not properly
equipped or your mechanics are not properly trained in
this type of repair, you may be time and money ahead
to replace complete assemblies.
■
Before
working
underneath,
instructions, securely block up, and check stability.
Secure blocking prevents equipment from drop-
ping due to hydraulic leak down, hydraulic system
failure, or mechanical component failure.
Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
CAUTION
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
GEARBOX REPAIR
NOTE: Read this entire section before starting any
repair. Many steps are dependent on each other.
1. Fill gearbox with SAE 80W or 90W gear lube.
Proper oil level for wing and center gearboxes is
between lowest ring and end of dipstick. On
splitter gearbox, fill gearbox until oil runs out the
side plug on gearbox.
NOTE: Repair to these gearboxes is limited to
replacing bearings, seals, and gaskets. Replacing
gears, shafts, and a housing is not cost effective.
Purchasing a complete gearbox is more economi-
cal.
2. Inspect gearbox for leakage and bad bearings.
Leakage is a very serious problem and must be
corrected immediately.
NOTE: Bearing failure is indicated by excessive
noise and side-to-side or end-play in gear shafts.
Seal Replacement
(Figure 10)
Recommended
sealant
T
Tge q oo gp
T Tge qo o gpfgf "ugcn cp v" hqt " ig ctd qz" tgr c kt "k
Leakage can occur at the vertical or horizontal gaskets
and shaft seals.
Leakage at the horizontal gasket or seal can be
repaired without removing the gearbox from the cutter.
MAN0764 (11/5/2008)
DEALER SERVICE
ARNING
read
manual
for
gearbox
repair
Seal Installation
NOTE: Proper seal installation is important. An improp-
erly installed seal will leak.
1. Clean area in housing where seal outer diameter
(OD) seats. Apply a thin coat of Permatex.
2. Inspect area of shaft where seal seats. Remove
any burrs or nicks with an emery cloth.
3. Lubricate gear shaft and seal lips.
4. Place seal squarely on housing, spring-loaded lip
toward housing. Select a piece of pipe or tubing
with an OD that will sit on the outside edge of the
seal but will clear the housing. Tubing with an OD
that is too small will bow seal cage and ruin seal.
5. Carefully press seal into housing, avoiding
distortion to the metal seal cage.
1. Seal
2. Pipe or tube
3. Seal seat
4. Casting
Figure 10. Seal Installation
Vertical Shaft Seal Replacement
1. Disconnect and remove driveline from the gearbox.
2. Remove dipstick breather assembly (30) and
siphon gear lube from housing through this
opening.
3. Remove crossbar (see page 30).
4. Remove retaining ring (33) and output oil seal (15).
Replace output oil seal (15) with new seal. Install
retaining ring (33).
NOTE: Distortion to seal cage or damage to seal
is
lip will cause seal to leak.
5. Fill gearbox with SAE 80W or 90W gear lube to the
center of the horizontal shaft.
6. Remove and replace any seal damaged in
installation.
Dealer Service 25
Pipe or tube must
press at outer
edge of seal.
Incorrect
Installation
(Figure 11
)
Advertisement
Table of Contents
