Table of Contents
Advertisement
SuperServer 2029BT-Hxxx User's Manual
Installing the Processor Heatsink Module
After assembling the Processor Heatsink Module (PHM), install it onto the CPU socket: Note
that there are two different heatsink models, SNK-P0067PS and SNK-P0067PSM. Use the
SNK-P0067PSM for CPU2 in each node.
1. Align hole 1 of the heatsink with the printed triangle on the CPU socket. See the left
image below.
2. Make sure all four holes of the heatsink are aligned with the socket before gently placing
the heatsink on top.
3. With a T30 Torx-bit screwdriver, gradually tighten screws #1 – #4 to assure even
pressure. The order of the screws is shown on the label on top of the heatsink. To
avoid damaging the processor or socket, do not use a force greater than 12 lbf-in when
tightening the screws.
4. Examine all corners to ensure that the PHM is firmly attached to the socket.
Oval D
Printed Triangle
Mounting the Processor Heatsink Module
onto the CPU socket (on the motherboard)
If at any time the PHM must be removed, power off, then loosen the screws in the sequence
of #4, #3, #2, and #1.
Oval C
Large Guide Post
Small Guide Post
T30 Torx Screwdriver
#4
#1
Tighten the screws in
the sequence of 1, 2, 3, 4
36
Use a torque
of 12 lbf-in
#2
#3
Advertisement
Table of Contents
