Replacing The Waste Toner Collector - Epson AcuLaser C8500 Quick Reference Manual

7. Take the new photoconductor unit out of its
package and unwrap the protective sheet while
holding the handle as shown below.
8. Holding the photoconductor unit by its handle,
place the unit on the guide rails and push it all the
way into the printer.
9. Turn the small lever to the left.
10. Turn the large lever 90 degrees clockwise.
11. Close the front cover.

Replacing the waste toner collector

The waste toner collector is sold as part of the
photoconductor unit because it usually needs
replacement at the same time as the photoconductor
unit. However, the waste toner collector is also sold
individually as sometimes you may need to replace the
waste toner collector separately depending on use.
Follow these steps to replace the waste toner collector:
1. Open the front cover.
2. Hold the handle of the waste toner collector and
push the tab down to release the lock.
5 5 5 5