BRUSHLESS SPEED CONTROLLER
Yokomo Brushless Speed Controller R160 / R100 Manual
Thank you for purchasing Yokomo product. This product has been developed to maximize the power of brushless
motor. R160 and R100 competition brushless controllers achieve high operability in wide range of R / C racing
scenes by changing settings. Various programming changes enables to set up according to the operation
(programming card available separately will be required). Please read this manual for settings and operations.
■ Specification
System
Forward / Brake / Reverse
Size
Weight
Voltage Input
Peak Current
Motor Limit
Motor Type
B.E.C
■ How to connect
● Use double-sided tape to fix the ESC in safe area.
● Pay close attention to the polarit y (+ and -) when
connecting the battery cable. If you make a mistake
between + and-when connecting to the battery, the ESC
will be damaged. In addition, please note that the failure
caused by this operation is not covered by the warranty.
Use BEC wire to connect the receiver to the ESC's 3-pin
port. (Do not mistake + and-)
● Solder 3 motor wires to ESC before connecting to the
motor. At that time, connect A-B-C wires of ESC and
A-B-C of motor that matches. When using solder, do not
apply solder for more than 5 seconds as it will become
hot and may damage the ESC. Damage during solder
installation is not covered by the warranty, so be careful
when working. After installing the solder, be careful that
the wires are not in contact with each other. If the wires
are in contact with each other and short-circuited, the
product will be damaged and the warranty will be invalid
● Connect the sensor cable to the ESC and motor.
● Connect the receiver cable to CH2 of the receiver..
* The output voltage of the FAN port is designed to be the
same as the battery voltage.
* A-B-C connected to the motor can be changed to C-B-A
by changing the programming card settings.
R160
● 32 bit processor ● Low resistance FET ● Auto Fan control
Factory default setting : Forward / Brake
38.1 × 30.5 × 19 mm
42g
4.5V ˜ 11V
6 cell Ni-Cd / Ni-MH Battery
2 cell Li-PO
760A
4.5 T
Sensored Brushless Motors
Brushless
30 × 30.5 × 12.5 mm
4.8V ˜ 11V
6 cell Ni-Cd / Ni-MH Battery
2 cell Li-PO
5A / 6V / 7.2V
R100
20.8g
380A
10.5 T