Advertisement
Factory default setting mode is BLINKY MODE.
1: Setup
Press the ENTER button from the opening screen.
Use the ▲ button or ▼ button and choose [A: Power Setting], [B: Brake Setting], [C: Timing Setting], [D:
General Setting], [E: Limit Value], [F: Load Setting] [G: Save Setting], [H: Firmware Update]
Press Enter to enter program mode or read data. It is divided into 8 modes.
* If you encounter any problems, please initialize the program box and then check the ESC settings.
Change settings with the four buttons located below the program box. The function of each button differs
depending on the screen display. "Select" button ----- Move to next item, and hold down "Select" button for 2
seconds ------- Return to the previous item.
▲ button ̶̶ Scrolls up.
▼ button-Scrolls down.
Enter button --The changed data will be sent to ESC and rewritten with new data.
* If program box and ESC settings are same, no data will be sent. Send Sucessed is displayed after data
transmission only when there is a change in the set value. If you have any doubts about the settings, you can
return to the default settings and then change the settings again.
2: Update
ESC firmware rewrite
Go to the Update menu and press Enter to see the current ESC firmware. Press Enter again to access the
firmware folder on the SD card. Select the firmware to use for updating ESC and press Enter again to start the
update. The update will take about 1 minute.
Advertisement
