Epson WorkForce 600 Important Setup Information

Important Setup Information

Network Connection

(Wireless or Wired)
1. If you're connecting to a network, use the
Ethernet cable that came with your product.
IMPORTANT:
Connect the cable for wireless or wired
networks. For a wireless connection, you'll
remove the cable later.
2. Set up your product using the Start Here sheet,
including setting the date and time. DO NOT
follow the steps in the "Install Software" section.
3. Install your software using the Network
Installation Guide.
For a variety of network setup information, go to:
www.epson.com/support/wireless
Direct Connection (USB)
1. If you are NOT installing your product on a
network, connect it using a USB cable (not
included).
You can purchase a USB cable at most
electronics stores.
2. Set up your product, including setting the date
and time, and install your software as described
on the Start Here sheet.
Ethernet network
cable (included)
Printed in/Pays d'impression : Indonesia
USB cable
(not included)
CPD-26496R1