Advertisement
OPERATION:
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure
that the lead is rated at 3 Amps or more, and that
it is fully unwound. If any other appliances are
connected to the same extension lead, make
sure that it is rated for the total power of all
appliances connected.
Switch the appliance on at the mains socket.
Connect the power and press Speed buttons (1,
2, 3). The fan will start to operate to the speed
level chosen.
TILTING THE FAN
You can adjust the angle of the fan by holding
the supporting tube and tilting the fan to the
required angle.
Tighten the nuts on the side of the fan slightly if
the fan will not stay in position.
ADJUSTING THE HEIGHT
(a) Loosen the height adjustment knob.
(b) Raise or lower the fan to the required height.
(c) Tighten the height adjustment knob to lock
the fan in the new position.
OPERATING COSTS
At time of going to press, the average cost of electricity is £0.12 per unit (kilowatt-hour).
The amount you are being charged will be shown on your electricity bill. At this cost, the appliance will
cost 8p per day to run on the "low speed" setting, 10p per day on the "medium speed" setting or 12p per
day to run on the "high speed" setting.
PAT TESTING
When used in an office environment, this product must be safety-tested yearly by a qualified electrician
(PAT Tested) in order to comply with the Electricity at Work. Regulations We recommend that it is PAT
tested regularly when used in a domestic environment.
5 |
P a g e
Advertisement
